MAN0597 ISSUE 08 - 02/04
2302M5030
2. GETTING STARTED
21
2.2 INSERTING THE CARTRIDGE
(1) If the instrument is switched on then switch it off by
pressing and holding the button. Note: if a cartridge
is already fitted, check that the instrument clock is
correct. If it is not, change the instrument clock as
described in section 4.1.1.
(2) Undo the two grille cover screws (5).
(3) If a cartridge is already fitted then remove it by undoing
the central screw.
(4) Insert new cartridge into aperture as shown. Ensure that
the point ‘%’ is located correctly in the pump or moulding
(depending on model).
(5) Gently tighten up the central screw to secure in place.
(6) Check the condition of the filter on the grille cover (3),
and if necessary, replace it.
(7) If the unit is fitted with a pump replace the pump seal.
%
To Next Page
Loading...
