MAN0597 ISSUE 08 - 02/04
2302M5030
2. GETTING STARTED
22
(8) Replace the front cover, and retighten the two screws
(5).
(9) Wait at least 20 minutes. Then switch the Impact on by
pressing the button and check no faults are reported
by the instrument. If fault 4 occurs refit the cartridge.
(10) Once the new cartridge is fitted the instrument will
compare it to the cartridge fitted previously. The
instrument will alert the user with warning if:
a) the alarm levels are different
b) the number of sensors is different
c) the mix of the sensors is different.
(11) If the instrument reports a gas alarm, switch instrument
off, wait 20 minutes, and switch unit on again.
2.3 CHARGE FOR FIRST USE
Either a rechargeable battery pack or a dry-cell battery source
can power the Impact. For the rechargeable battery it must be
charged before first use, to replace any battery capacity used
during transit and storage.
(1) Ensure the basestation is connected to a suitable power
source.
(2) Place the instrument in the basestation.
The basestation employs a locking mechanism to
ensure that the Impact is retained under most operating
conditions. To ensure this operates correctly the
following procedure should be followed:
To Next Page
Loading...
