Honeywell Impact - Removal of the Pump Adaptor; Menus

MAN0597 ISSUE 08 - 02/04
2302M5030
4. OPERATION
47
4.6.1 Removal of the Pump Adaptor
To ease the removal of the Pump Adaptor, follow the steps
below.
(1) Support the end of the Pump Adaptor close to the inlet
port using the thumb of one hand.
(2) Press on the top of the clip using the thumb of the other
hand until a click is heard.
(3) Lift the Pump Adaptor clear of the instrument.
4.7 MENUS
While the gas monitoring screen is displayed, pressing the "
button will provide access to menus, depending on the model.
Note: Calibration is not permitted until the sensors have
warmed-up and been self tested or if the pump is
running. If you access the user menu under any of these
circumstances the Calibration option will not be
available.
User Menu
Flammable
Calibration
Operator
Instrument
Safelink
Language