Honeywell INTELLIGUARD 9000 - Testing; Testing Hold-Up Actuators

INTELLIGUARD 9000™
19 74-3047—1
NOTES:
— Connect other devices that re
q
uire 12 Vdc to VX1
(
TB4-1,2 or VX2
(
TB5-1,2
)
for power and connect
the ISP COM TxRx-
(
TB4-3
)
and TxRx+
(
TB4-3
)
to CU COM 1 or 2, but not both.
— The RS485 COM Port connector
(
J1
)
is onl
y
intended for use b
y
field personnel for a tempo-
rar
y
CC2 plu
g
-in. Note that power is derived from
VX1 and the COM is the same COM used for the
ISP.
(
This connection is not usuall
y
used since
learnin
g
can be done usin
g
PRO9000.
)
The fol-
lowin
g
restrictions appl
y
:
1.
Maximum number of devices is 31 for either COM 1 or
COM 2.
2.
Maximum number of CC2s on the s
y
stem must not
exceed four.
3.
A free CC2 address is re
q
uired to prevent conflicts with
other CC2s
(
disconnect another CC2 temporaril
y
, if nec-
essar
y)
.
See Fi
g
.19 to install the RRI Communication Interface
Modules.
Fig. 19. RRI mounting locations.
RS-232 to RS-485 Interface (RRI) 8003-321
The RS-232 to RS-485 Interface
(
RRI
)
8003-321 is used to
extend the I9000
(
COM 3
)
to the EBI communication link for
distances in excess of 50 feet. This distance can be extended
to 3277 feet
(
999M
)
usin
g
the RS-485 with the RRI.
The 8003-321 Assembl
y
is re
q
uired for the Pseudo RS-232 to
RS-485 Interface installation. The Assembl
y
includes the
followin
g
parts: Plastic Track, Part no. 7003-217, Retainin
g
Clip, Part No. 1041-004 and Pseudo RS-232 to RS-485
Interface
(
RRI
)
, Part No. 8003-322.
M14497A
TB1
TB2
TB TB
PLASTIC TRACK
7003-217
4 MOUNTING HOLES
FOR NO. 8 ROUND
PAN HEAD SCREWS
INSTALL AND SECURELY MOUNT RRI COMMUNICATION INTERFACE MODULES USING THE PLASTIC TRACK (INCLUDED) AS SHOWN. TWO TRACKS MAY BE
SUSPENDED FROM THE TOP EDGE OF THE INTELLIGUARD ENCLOSURE OR ONE TRACK MAY BE INSTALLED ON THE RIGHT SIDE NEXT TO THE BATTERY.
RETAINING CLIP
1041-004
ENCLOSURE
SIDE
1/2 IN. (13 MM) KNOCKOUT (4 PLACES)
7/8 IN. (22 MM), DIAMETER
TAMPER SWITCH
5115-094
INTELLIGUARD ENCLOSURE
TRACK
SIDE
POWER SUPPLY ASSEMBLY INTELLIGENT COMMUNICATIONS
PROCESSOR (ICP)
BATTERY 12V, 7.0 Ah
YUASA NO. NP7-12
HPS NO. 4002-037
OR EQUIVALENT
GROUND
LUG
BATTERY 12V, 7.0 Ah
YUASA NO. NP7-12
HPS NO. 4002-037
OR EQUIVALENT
1
1
1