Honeywell INTELLIGUARD 9000 - Terminal Specifications

INTELLIGUARD 9000™
27 74-3047—1
APPENDIX A
TERMINAL SPECIFICATIONS
Table 3. Connector Terminal Specifications.
a
SIG = Si
g
nal.
b
Polarit
y
of the RS-485 in the I9000 s
y
stem is opposite from the industr
y
standard.
Connector Terminal Pin(s) Signal Name Input/Output
Voltage
Type
a
Maximum
Voltage
Maximum
Current (Rx/Tx)
Maximum
Frequency
Comm. Processor TB1-1 12 Vdc- Power dc 0V 45 mA —
TB1-2 12 Vdc+ Power dc +15V 45 mA —
TB1-3,5 A-, B- In/Out SIG -6+11V 1mA/150 mA 4800 baud
TB1-4,6 A+, B+ In/Out SIG -6+11V 1mA/150 mA 4800 baud
TB1,7 CU Tamper- Input dc level 0V 16 mA —
TB1-8 CU Tamper+ Input dc level 0, +5V 16 mA —
TB2-1 Rx Input SIG ±12V ±18 mA 4800 baud
TB2-2 Tx Output SIG ±9V ±18 mA 4800 baud
TB2-4 Dir Output SIG ±9V ±10 mA 4800 baud
RRI Interface TB2-3
DAT-
b
In/Out SIG -6+11V 1 mA/150 mA 4800 baud
TB2-4
DAT+
b
In/Out SIG -6+11V 1 mA/150 mA 4800 baud