Honeywell LKS 160 - Technical Specifications; Specification Overview

3 EN2C-0112SZ20 R0202
Diagram Shaft Drive Load torque Holding Voltage Type Remarks
time torque
Nr. Nr. s Nm Nm V
S1 5 5 2,5 0,8 230 LKS 160-01 A 5-5 S1 standard version
S2 5 5 2,5 0,8 230 LKS 160-03 A 5-5 S2 standard version
S1 5 12 3 1,5 230 LKS 160-07 A 5-12 S1
S1 5 5 2,5 0,8 230 LKS 160-09 A 5-5 S1 Spindle-driven cam
S7 5 30 3 3 24 LKS 160-22 A 5-30 S7
S7.1 5 30 3 3 110 LKS 160-24 A 5-30 S7.1
S6 5 34 3 3 230 LKS 160-25 A 5-34 S6
S1.2 5 34 3 3 230 LKS 160-26 A 5-34 S1.2
S1 5 12 3 1,5 230 LKS 160-37 A 5-12 S1
S4 5 5 2,5 0,8 230 LKS 160-39 A 5-5 S4
S2 5 3 1,5 0,6 230 LKS 160-40 A 5-3 S2
S13 5 45 3 3 230 LKS 160-42 A 6-45 S13 Spindle-driven cam
S8.P1.1 5 34 3 3 230 LKS 160-44 A 5-34 S8.P1.1 Potentiometer can be retrofitted
S8.P2 5 30 3 3 110 LKS 160-55 A 5-30 S8.P2 Potentiometer can be retrofitted
S8.P4 5 45 3 3 230 LKS 160-59 A 5-45 S8.P4 with Potentiometer, special circuit
S8.P 6 34 3 3 230 LKS 160-63 A 6-34 S8.P Potentiometer can be retrofitted
S8.P4.1 5 38 3 3 120 LKS 160-65 A 5-38 S8.P4.1 Run time at 60 Hz, with Potentiometer,
special circuit
S8.P3 5 30 3 3 24 LKS 160-67 A 5-30 S8.P3 Potentiometer can be retrofitted
S8.P1.1 5 34 3 3 230 LKS 160-68 A 5-34 S8.P1.1 Potentiometer can be retrofitted,
spindle-driven cam
S8.P1 5 5 2,5 0,8 230 LKS 160-70 A 5-5 S8.P1
S4 5 3 1,5 0,6 230 LKS 160-73 A 5-3 S4
S15 5 5 2,5 0,8 230 LKS 160-75 A 5-5 S15 For 3-stage operation
S2 5 12 3 1,5 230 LKS 160-79 A 5-12 S2
2) 3)
4)
6)
5)
7)
1)
SPECIFICATION
TECHNICAL DATA
Type overview
clockwise rotation
Legend
1) when viewing from direction A (see dimensional drawing)
2) see “Circuit diagrams”
3) see “Dimensional drawing”
4) at 50 Hz for 90°
at 60 Hz, Drive times are about 20 % shorter
5) under nominal conditions
under extreme conditions (e.g. +60 °C, 230V -15%) the torques will be 25% lower
6) +10% -15%; 50...60Hz
at -15%; torque reduced by approx. 20% at undervoltage
7) Standard: Lever-operated cam