LYRIC T6 SMART THERMOSTAT
LYRIC-T6-EN0H 8603 NL01 R1216
To ensure your safety, always make sure mains power is switched OFF before accessing wiring.
Before removing the old thermostat take a picture of the old thermostat’s wiring as a reference then proceed to installation.
The Lyric T6 thermostat should not be placed near draughts, in direct sunlight or near heat sources. It should be at least 1.2 -
1.5 meters from the floor.
Maximum cable length between Receiver box and thermostat: 15m for 0.5mm² cable or 20m for 1.0mm² cable.
Needed during installation:
Cable with 2 wires from the Receiver Box (R4H810A) to thermostat.
Cable with 2 wires from the boiler to Receiver Box.
The Receiver Box requires 230V power
Find a suitable location near the boiler. Leave at least 30cm distance from any
metal objects including wall boxes and boiler housing.
Loosen the front screw to remove cover or tighten it when the cover is back in
position.
A. Wall box or Rear wiring
Hinge open the terminal block flap to access
the cables and wall box screw holes.
B. Surface wiring
Use the cable clamps to secure the
surface wiring.
Replace cover
Locate the hinges at the top of the
cover and wall plate, close the
cover and secure with the screw.
Note: See the wiring diagrams on page 9 for the correct wiring connections.
To Next Page
Loading...
