4
Connect to Wi-Fi
1 Choose your network from
the list. Press NEXT.
2 Enter your Wi-Fi password, if
necessary. Press NEXT.
3 When connected to Wi-Fi,
the LED will turn solid green
for 5 minutes, then turn o to
preserve battery life.
Note: If you remove and replace
the detector’s batteries, it will reconnect to your Wi-Fi network
automatically.
4 Configure
Continue to follow the instructions in the app to
configure your detector. Set the high and low
levels for humidity and temperature warnings,
and identify the people you want notified in case
of an alarm. These settings can be updated at any
time using the app.
32325307_A.indd 4 3/7/2017 4:41:30 PM
To Next Page
Loading...
