8
Wi-Fi® is a registered trademark of Wi-Fi Alliance®
Honeywell Novar ED&S
The Arnold Centre,
Paycocke Road,
Basildon, Essex, SS14 3EA
United Kingdom
getconnected.honeywell.com
© Honeywell 2017
In case of an alert
When water is detected, it can take the detector up to 1 minute to
sound the alarm and send a notification to the user.
You can mute the detector by pressing the Mute button in the app
or removing the batteries or cable sensor from the detector. The
mute command may take up to 1 minute to reach the detector.
After the alert, wipe dry the detector and cable sensor and put
them back in place. Replace batteries if they were removed.
Caution: The detector can only take in a moderate amount of water
and may become unusable if fully submerged. If this occurs, remove
the device from water, dry it and test it for functionality. If it is still
not performing properly, replace the device.
32325307_A.indd 8 3/7/2017 4:41:31 PM
To Next Page
Loading...
