Honeywell Lyric - Program RF Keypad

Lyric Controller Programming Guide
Program RF Keypad
The Lyric supports the installation of up to eight SiX™ Series RF keypads. The Keypad should be setup in
accordance with the documentation provided with the keypad prior to beginning the enrollment process. A
Zone Descriptor should be assigned to each enrolled Keypad to ensure that Zones can be easily identified.
Programming Field
Function and Action
RF Keypad
Select a keypad zone from the available options, then select “Add New” to enroll the
RF Keypad OR select “Add New” to enroll the RF Keypad in the next available zone.
850. Keypad
852. Keypad
854. Keypad
856. Keypad
851. Keypad
853. Keypad
855. Keypad
857. Keypad
Select a zone and then select “Edit” or “Add New” to program the next available zone.
The following options are displayed:
Serial Number
Zone Description 1 Zone Description 2
Supervision
Time
Serial Number
When “Serial Number” has been selected “Enter Serial Number or Activate” is
displayed. Follow the applicable steps below to enroll the SiX™ Keypad.
(Refer to the documentation provided with the SiX™ keypad for additional information.)
1. Apply power to the RF keypad. Allow up to 20 seconds for pairing to complete. If
the keypad has been successfully paired with the control, the “Pairing Complete”
will be displayed. If the pairing is not successful, remove electrical power and
disconnect the battery.
2. Reinstall the battery and repeat step 1.
3. The device serial number is displayed on the Lyric screen and the system beeps
three times and returns to the Zone Programming Screen.
4. The device’s battery level and signal strength are displayed on the Lyric control.
Zone Description1/
Zone Description 2
Select “Zone Description 1 or Zone Description 2”. Using the displayed keypad enter
Zone Description 1 or Zone Description 2. The system announces the Zone Description.
Enter “Done”, when you are finished. The system returns to the Zone Programming
page.
NOTE:
When programming the Zone Description, after entering the first letter of the
description on the keypad, use the up ˄ and down ˅, arrows to scroll through
the available preprogrammed zone descriptions.
Supervision Time
(minutes)
The Supervision Time is not programmable locally and is set to 60 minutes
- 24 -