Honeywell Lyric - Communication Diagnostics

Lyric Controller Programming Guide
Communications Diagnostics
For additional information regarding these fields, refer to the Lyric Controller Installation and Setup Guide p/n
800-18076 or higher.
Communication Diagnostics
Use the down “
˅”
arrow to scroll to the next page of options. Use the “
˄
” arrow to return to the previous
page. Choose from the following options (depending upon the Communication Module that is installed):
Configure WiFi
– Provides access to the options for connecting the Lyric Controller panel to a WiFi Network
WiFi Information
– Displays IP information if the WiFi Communication Path is enabled.
Cellular Information
- Displays Cellular information if the Communication Path is enabled and the device is
registered.
Communication Status
– Displays status of the WiFi or Cellular Communications Paths and performs a self-
test of the advanced encryption standard (AES) algorithm.
Test Communication
– Performs network diagnostics and sends test alarms to the network.
Setup Communication
– Resets factory defaults.
Communication ID Numbers
– Displays programmed information for the installed communication module.
Configure WiFi
1. Select “Comm. Diagnostics” from the Installer Programming screen to connect the Lyric Controller panel
to a WiFi Network.
2. Select “Configure WiFi”. The System displays the following options:
Scan Access Points
Manual Configure AP
WPS
Automatic Video Recovery
Enroll using Scan Access Points
NOTE:
If the preferred access point is not available after scanning, manually select the network via the
“Manually Configure Access Points” procedure
.
1. Select “Scan”. The available networks and signal strength are displayed. Use the down “∨” arrow to scroll
to the next page of options. Use the “
∧” arrow to return to the previous page.
Bars
Meaning
RSSI range (dBM)
4 White
No connection
-255 (used internally)
1 Yellow, 3 White
Weak
-81 or higher
2 Yellow, 2 White
Fair
-71 to -80
3 Yellow, 1 White
Good
-51 to -70
4 Yellow
Excellent
-50 or less
3. Select the desired Network and then press the “Edit” button. The network information is displayed. If the
network is not password protected, select the “Join” button. A confirmation screen will be displayed.
4. Select the “Key” button and enter the password for the WiFi Network, then select the “Save” button.
5. Select the “Join” button. A confirmation screen is displayed.
6. Select “OK.
7. Select the “
” button. The WiFi information will be displayed. Signal strength is indicated by a series of
colored bars along with the RSSI level (in dBM).
Manual Configure AP (Access Point)
1. Select “Manual Configure AP”.
2. Select “SSID Name” and then enter a name (not to exceed 31 characters) on the displayed keyboard.
3. Select “Security”. The system scrolls between the following options:
Open
wpa/wpa2
WPA2
WEP
4. Select “Network Type”. The system scrolls between “Infrastructure” and “Ad-Hoc”.
5. If a password is required, select “Key” and enter the password.
6. Select the “Join” option.
7. “Device successfully added to the Network” is displayed. Select “OK to confirm the selection.
8. Select the “” option. The WiFi information will be displayed. Signal strength will be indicated by a series
of colored bars along with the RSSI level (in dBM). (Refer to the table above.)
- 25 -