Lyric Controller Programming Guide
Programming the Data Fields
1. Select each desired programming option, and then select the required entry. The system beeps each time
a selection is made.
2. The system will toggle or scroll through the options or display a new screen as applicable.
3. To delete or change an entry, select the desired option, and then select the required entry.
4. Select “Save”
Exiting Programming Mode
1. Select the “” key to exit the current screen. The system returns to the previous screen.
2. Select the “” key as required until the system returns to the Security Screen
3. Select the “” key OR depress the Home button to return to the Home Screen.
Loading a Default Set
Refer to the Programming Default Values section of this manual to view the default values.
1. Select ‘Default Config’ and select the appropriate Default Configuration from the
following options:
Default Config 1
Default Config 2
Default Config 3
Default Config 4
For a list of the pre-programmed defaults refer to the Default Values section.
2. Select the desired Default Configuration.
3. A Confirmation screen is displayed.
4. If “Yes” is selected, the System beeps three times and returns to the Default
Config. screen.
5. If “No” is selected, the System beeps once and returns to the Default option
screen.
Reset Master User Code
1. The system displays a confirmation screen. Select the “Yes” key to reset the
Master User Code to “1234”.
2. If confirmed, the Master Code will be reset back to “1-2-3-4”. This will be logged
in the System Event Log as “Reset Master Code User 2 E655”. The system
returns to the second page of the Installer Programming Tools menu. OR
If the reset failed, the system will display: “Command Failed. Unable to Reset
Master Code”.
Security Code Notes
• The Master and Secondary security codes permit access to the system for arming, disarming, etc.
• The Installer Code can disarm the system only if it was used to arm it. In addition, the Installer Code cannot
disarm the system if it was armed by pressing and holding a Quick-Arm button.
• The Guest Code can disarm the system only if it was used to arm it. In addition, the Guest Code cannot disarm
the system if it was armed by pressing and holding a Quick-Arm button.
• Duress code sends a special code to the monitoring station when used to perform any system operation. Instruct
users to be careful not to use this code for normal usage.
• Opening/closing reports are sent for the Installer Code, with the appropriate subscriber number. Master Code
and set of secondary user codes are sent as No. 2 and 3-48 respectively, in Contact ID® format (with the
appropriate user number).
- 7 -
To Next Page
Loading...
