- 2 -
Using the Home app with Lyric
Using the Home app with LyricUsing the Home app with Lyric
Using the Home app with Lyric
To operate Lyric Controller via the Home app, press and hold
the
the the
the Lyric icon as seen in the previous
illustration. Arming options appear as seen below.
At left
At leftAt left
At left:
Lyric’s current security status
is displayed at the top of the
screen.
Tap one of these
arming/disarming options
(they’re described in the next
section).
• Home
• Away
• Night*
• Off
Tap Details
DetailsDetails
Details at the bottom to review information about your system and customize the way it interacts with
HomeKit. The Location
Location Location
Location setting allows you to label the Lyric Controller with the name of the room where it is
installed.
If only part of the Details screen (shown above right) is displayed, you can scroll to see all the settings and
other information.
Arming/Disarming from the Home app
Arming/Disarming from the Home appArming/Disarming from the Home app
Arming/Disarming from the Home app
The Home app’s arming commands correspond with Lyric’s Arm/Disarm modes as follows:
Home
Home Home
Home app Lyric
LyricLyric
Lyric
Home Arm Stay
Away Arm Away
Night* Arm Night
Off Disarm
• Alarm and Arm/Disarm notifications appear on the iOS device whether the Home
app is running or not.
• No Lyric user code is required for any of these commands sent from the app.
* The Home app command Night
NightNight
Night is inactive unless Arm Night
Arm NightArm Night
Arm Night is enabled in Lyric Controller. [See the Lyric
Controller User Reference Guide (P/N 800-18078 or higher) for more information on Arm Night.]
To Next Page
Loading...
