22 MagneW 3000
PLUS
Specification and Application Guide 1/98
Table 6—Specifications for MagneW 3000
PLUS
, continued
Design (continued)
Wetted Materials
Lining:
• 2.5 to 600 mm (0.1 to 23.6 in.) diameters—PFA
• 25 to 200 mm (1 to 7.9 in.) diameters—polyurethane rubber
• 250 to 600 mm (9.8 to 23.6 in.) diameters—chloroprene rubber
Electrode:
SUS316L, Hastelloy C, Titanium, Zirconium, Tantalum, Tungsten-Carbide,
Platinum/Iridium
Ground ring:
SUS316, Hastelloy C, Titanium, Zirconium, Tantalum, Platinum
Union joint for diameters 2.5 to 15 mm (0.1 to 0.6 in.):
SUS316
Hose for diameters 2.5 to 15 mm (0.1 to 0.6 in.):
SUS316
IDF clamp:
SUS316
Tri-clamp:
SUS316
Gasket:
PTFE gaskets are supplied with ground rings of Hastelloy C, Titanium, Zirconium,
Tantalum, and Platinum. For ground rings made of SUS316, gaskets are supplied by customer;
non-rubber, such as PTFE or joint sheet, is recommended.
O-ring:
Viton rubber (with union joints)
Electrical Conduit 1/2 inch NPT, G1/2, CM20, Pg13.5 internal threads, optional plastic and brass waterproof glands
(G1/2 only)
Nuts and Bolts For wafer construction models only
S20C carbon steel, SUS304 stainless steel
Electrical Connection
Integral:
M4-12P screw terminals
Remote:
• Converter—M4-19P screw terminals
• Detector—M4-5P screw terminals
Cables
Signal cable:
2-core individually double-shielded cable
Coil excitation current cable:
2-core chloroprene cabtyre cable
Cable Length 300 meters (984 feet) maximum
Grounding Category 3
100 ohms maximum ground resistance
Dimensions See Figures 12 through 20, as applicable.
Weight
Converter:
3.7 kg (8.2 lbs)
Detector:
Refer to Table 8, 9, or 10, as applicable.
To Next Page
Loading...
