Honeywell MAXPRO NVR Hybrid XE - Figure 6-9 Graphical Illustration

. . . . .
CONFIGURING MAXPRO NVR
Configuring the Disk Management Settings
MAXPRO NVR 5.0 Installation and Configuration Guide 125
You can also view a graphical illustration of the drive statistics with legends for each of the
above fields see Figure 6-9.
Figure 6-9 Graphical Illustration
•In the Recording recycle at box, type a value. The Recording recycle refers to a
state when the oldest video recordings are automatically deleted, if there is no disk
space on the drives for new video recordings.
•In the Low disk alarm at box, type a value. The Low disk alarm refers to a state when
the space on the drives for video storage is nearing the maximum size of the drives.
Caution: The Low disk alarm at value must be always greater than the Recording
recycle at value.
Tip: Click Refresh to refresh the information under Disk Space at any point in time.
5. Click Add Drive to add a fixed drive or a network drive.
• The fixed drive that you are adding must be available on the MAXPRO NVR system,
else an “Invalid Drive” text displays in the Total Space (GB) column.
• Add Network Drive using map drive as \\Drivename\Folder.
• Add a network drive path in the following format: \\<IP address >\<folder name>
for example, \\192.168.1.12\Recorded Clips.
Note: The Network drive added must be valid with proper folder permissions set for the
installed default user, else an Invalid Drive text displays in the Total Space (GB)
column.