Honeywell MAXPRO NVR Hybrid XE - Figure 6-31 Equip- Fisheye Camera Settings

CONFIGURING MAXPRO NVR
Configuring the Cameras
156 MAXPRO NVR 5.0 Installation and Configuration Guide
6
2. On the Camera page, for the New EquIP Fisheye Model (HFD6GR1) camera, click on
the left corner to open the camera properties pane see Figure 6-12.
Figure 6-31 EquIP- Fisheye camera Settings
3. Under General > 360 Settings, select the Enable check box to enable the dewarping
feature.
4. Under General > 360 Settings
• Select the Mounting Position. You have three options to choose from: Wall, Ceiling,
and Ground. Based on the mounting position the views are displayed.
5. Click the Get Configuration button. The dewarping configuration takes a while to
download the dewarping configuration. A message Successfully downloaded
configuration is displayed in the bottom of the camera screen.
Note: For each Mounting Position, you need to click Get Configuration button to
download the corresponding configuration.