Honeywell MAXPRO NVR Hybrid XE - Step 4: Update the NVR Services with New Service User Account Credentials

SECURING MAXPRO NVR
Step 4: Update the NVR services with new Service user account Credentials
258 MAXPRO NVR 5.0 Installation and Configuration Guide
11
3. Type the following:
• UserName: Provide the username (For example: NVRServiceUser2) of the new
account created in Step 3: Create a new Service User and Deny log on.
• User Description; Provide the description as Administrator.
• Role: Provide the role as NVRAdministrator.
• Password: If you select the Is Window User check box then you don't have to
provide the new password created.
• Select the Is Window User check box for the new user (For example:
NVRServiceUser2).
4. Click Save and close the MAXPRO NVR application.
Step 4: Update the NVR services with new
Service user account Credentials
1. Launch the Services (Run > Services.msc.) window and Stop the following services in
the order mentioned:
• NeoStorageExtWDService
• NEOStorageServer
• NEOStorageServer2
• TrinityArchival (Applicable only for 4.0 Release version)
• TrinityController
• TrinitySmart VMD services
• TrinityServer
2. Right-click on TrinityServer service and then click Properties. The TrinityServer
Properties dialog appears.
3. Click the Logon tab.
4. Under This account option:
•Replace the Username from ./Administrator to ./NVRServiceUser2 which is
created in Step 3: Create a new Service User and Deny log on in Section .
• Type the Password which is created in Creating password for the new
account section.
• Confirm the Password.
5. Click Apply and then click OK.
Note If you are changing the username of a service for the first time then a service Pop
message The account xxxx has been granted the Log On As a service right is
displayed. Click OK to proceed.