MAXPRO NVR 5.0 Installation and Configuration Guide 315
A
Appendix A
Customizing IP Address and Machine Name
and Scheduling Metadata and Database
Backup
Changing the Default IP address and Machine
Name
See the Changing the MAXPRO NVR IP Address and Machine Name section on page 49 for
more information.
Scheduled Metadata and Database Backup
A common batch file is created for taking the scheduled metadata and database backup.
The following sections describe the procedures to setup scheduled metadata and database
backup.
Note It is recommended to set up scheduled backups of Metadata and
Database with the below steps if they are not already configured on your
NVR. The backups can be used to recover a system anytime later in case
of a failure or if the OS drive is reimaged with a recovery disk, please
contact Technical Support for assistance. Please note the below steps do
not include backup or recovery of the Video Storage drives containing the
raw video data. Below is the recommended configuration:
a. Separate Metadata partition (For example M:) of 50 GB or higher size on the
non-OS hard drive. Metadata can be pointed to the separate partition during
the install/upgrade.
b. The database backup is recommended to be pointed to the Metadata
partition.
c. The Metadata backup is recommended to be pointed to the OS partition.
To Next Page
Loading...
