Honeywell MAXPRO NVR Hybrid XE - Configuring the Pre and Post Event Recording Settings; Configuring Camera Settings for VMD-Based Recording; Figure B-2 Camera Configuration Page

APPENDIX B
VMD Settings and Motion-based Recording Configuration
332 MAXPRO NVR 5.0 Installation and Configuration Guide
B
Configuring the Pre and Post Event Recording
Settings
See the Event Recording Settings section on page 114 for more information on configuring
the pre and post event recording settings.
Configuring Camera Settings for VMD-Based
Recording
1. Click the Configurator tab and then the Camera tab to open the Camera configuration
page (Figure B-2).
Figure B-2 Camera configuration page
• For built-in (Camera-based) VMD configuration, open the camera web page by
clicking Launch Web View for Advanced Setup. See the Configuring Built-in VMD
(Camera based VMD) on Honeywell IP Cameras section on page 315 for more
information.
• For Server-based VMD (SMART VMD) configuration, select the Enable SMART VMD
check box and click Configure. See the Server VMD (SMART VMD) section on
page 315 for more information.
Note: Built-in (Camera-based) VMD support in NVR is based on the type of device
integration and may not be supported for all devices. Please refer to the MAXPRO
NVR compatibility list on HOTA website
(http://www.security.honeywell.com/hota/) for details. Server VMD (SMART VMD)
is supported for all video devices supported by NVR.