COMMISSIONING MAXPRO NVR
Steps in the Commissioning Procedure
46 MAXPRO NVR 5.0 Installation and Configuration Guide
2
The following steps are involved to install the MAXPRO NVR software on a 3rd party hardware:
1. The server and client computers meet the minimum hardware and software requirements.
2. Installing the MAXPRO NVR software.
Caution: Don't install any Email client on the MAXPRO NVR server machine.
See the MAXPRO NVR Software Installation section on page 66 for information on software
requirements and installation instructions for the MAXPRO NVR software.
Configuring the MAXPRO NVR
In this phase, you need to configure the MAXPRO NVR through the user interface. Configuring
MAXPRO NVR includes the following:
• Configuring the Honeywell cameras with MAXPRO NVR Wizard
• Configuring the system level settings
• Configuring the disk management settings
• Configuring the schedule based recording for cameras
• Performing user administration
See the Configuring MAXPRO NVR section on page 109 for information on how to configure
the MAXPRO
NVR system.
Verifying the Configuration
Verifying the configuration involves checking whether the surveillance operations can be
performed using MAXPRO NVR. Surveillance operations include: viewing the live video,
performing the pan, tilt, and zoom on the video, and starting the video recording.
See the Verifying the Configuration section on page 195 for information on how to perform the
verification.
To Next Page
Loading...
