Honeywell MAXPRO NVR Hybrid XE - Figure 3-3 Network and Sharing Center; Figure 3-4 LAN Properties

SETTING UP THE MAXPRO NVR
Setting up the MAXPRO NVR Turnkey Box Solutions
50 MAXPRO NVR 5.0 Installation and Configuration Guide
3
Note: NIC2 may not be available on all NVR options, please refer to the data sheet for
more information.
If more than one MAXPRO NVR unit is on the same network, you must assign a unique IP
address and computer name to each unit (the default name is MAXPRO-NVR).
Changing the IP address
1. Click the network icon in the notification area, click Open Network and Sharing
Center (See Figure 3-3), and then click Change adapter settings.
Figure 3-3 Network and Sharing Center
2. Right-click Camera Network or Client Workstation Network, and then click Properties.
The Local Area Connection Properties dialog box (Similar to Figure 3-4) appears.
Figure 3-4 LAN Properties
3. Click Internet Protocol Version 4 (TCP/IPv4), and then click Properties.