. . . . .
INSTALLING THE NVR SOFTWARE
Overview
MAXPRO NVR 5.0 Installation and Configuration Guide 65
To delete the Scheduled task manually or using Cmd prompt
• Manually: Control Panel->System and Security->Administrative Tools-
>Task Scheduler->Task Scheduler Library->Delete TrinityBackupScheduler
OR
• Through Cmd Prompt: C:\windows\system32\"SchTasks.exe" /Delete /TN
"TrinityBackupScheduler" /F
Note: Ensure that services.msc console is closed before Installing or upgrading the
MAXPRO NVR.
Before you Begin - Disable Defragmentation
Before starting the installation of MAXPRO NVR, it is recommended that you disable
Defragmentation.
1. Click Start -> Run -> type DFRGUI.
2. In the Disk Defragmenter dialog click Configure Schedule
3. Click to clear the Run on the schedule (recommended) check box.
4. Click Start, (Right-click) Computer-> Manage, select Task scheduler ->Task
scheduler library -> Microsoft -> Windows -> Defrag. Right-click on the
ScheduleDefrag and then select Disable.
5. Perform the following steps to make changes in the Registry Settings to disable
defragmentation at boot time:
a. Open the Registry Editor. Navigate to HKEY_LOCAL_MACHINE>SOFTWARE>
Microsoft> Dfrg> BootOptimizeFunction.
b. Right-click on the keyword "Enable" and then click Edit..
c. In the Value Data field type, N and then click OK..
d. Right-click on the keyword "Optimizecomplete" and then click Edit.
e. In the Value Data field, replace Yes with No. (case sensitive) Click OK..
f. Close the Registry Editor. The changes take effect when Windows is restarted.
Before you Begin - Disable Volume Shadow Copy,
Windows Backup Services
1. Turn off the Protection settings for all the drives including OS installed drive in My
Computer -> Properties -> Advanced System Settings -> System Protection tab.
2. Select the drive under Protection settings and click Configure.
3. Under Restore Settings select Turn off system protection and click OK.
To Next Page
Loading...
