Honeywell Miller Revolution Harness - ENSURING A SNUG FIT; Adjusting Cam Buckles for Fit; INSTALLING OPTIONAL ACCESSORIES; Connecting Accessories to Harness

7
STEPS FOR ENSURING A SNUG FIT
D. Adjusting Cam Buckles
D.1 Unclip the web end nial from the webbing.
D.2 Pull webbing downwards to adjust tighter
D.3 Reposition web end nial.
INSTALLING OPTIONAL ACCESSORIES
E. Connecting Accessories
E.1 Locate the gure « 8 » shaped composite attachement clip on the back of the accessory.
E.2 Identify the green button attachement point on the belt or harness that will be used.
E.3 Place the widest end of the gure « 8 » over the green connection button.
E.4 Push the accessory downward until you feel it snap into place.
E.5 To remove, reverse procedure by gripping 1 loop and pulling upward. Miller integrated accessories have a
weight limit of 11kg, when connected via the composite link. For loads heavier than 11kg, connecting to a belt
via the tunnel loop is recommanded for more even weight distribution. The combined weight of the harness
user, and all attached tools and accessories should not exceed the maximum capacity of the fall protection
system being used.
D.1
D.2 D.3
E.1
E.2 E.3 E.4