Honeywell MIWI350 - 5.2.2 Power Distribution Board jumper settings for Alkaline Battery or DC input

86 pages

To Next Page

To Previous Page

|32

5.2.2 Power Distribution Board jumper settings for Alkaline Battery or DC input

Figure 5-4: Power Distribution Board

Caution: Never exceed 9V for Alkaline battery input. The supercap connected cannot work beyond 9V.

5 Electrical Assembly

Main Page

Table of Contents4
About MIWI3506
Product Features6
Power Supply Options6
Abbreviations6
Specifications7
Power Input Sources and Options7
Audit Trail8
Certifications8
Wiring Guidelines for AC Input9
Environmental10
Temperature Measurement11
Pressure Measurement11
Safety Measures12
Safety and Hazardous Information12
Conditions of Acceptability13
Warning-Explosion Hazard/Avertissement - Risque D'explosion13
Things to Remember14
Usage of MIWI350 in Hazardous Areas14
Installation and Commissioning of MIWI350 in Hazardous Areas14
Instructions for Installation in Zone 2 Location as Per Iecex Certification14
Service, Maintenance, and Troubleshooting14
Security Control Measures16
Installation19
Unpacking19
Mounting Options19
Device Marking20
Zone2 Installation21
Mechanical Assembly and User Interface23
Device Dimensions & Weights24
Display Options26
HMI User Interface27
Gland Entries30
Power Input30
Temperature Input31
Electrical Assembly33
Input or Output Board33
Power Distribution Board34
Power Distribution Board Connections for Solar-Input/Ac-DC Input with Lead Acid Battery Back up36
Power Distribution Board Jumper Settings for Alkaline Battery or DC Input37
Power Distribution Board Output Voltage and Jumper Settings38
Modem38
Remote Pulser39
Pulser to MIWI Cable Connections40
Internal Wiring43
Power Distribution Board and IO Board43
Power Distribution Board and Modem43
IO Board and MODEM45
Battery Installation47
Lead-Acid Battery47
Dual/Quad Alkaline Battery48
Battery Life (Approximate)49
SLA Alarm Scenarios50
Reference Drawings52
MIWI350 with EC350 or ERX35052
Wiring Dual or Quad Battery52
Wiring AC-DC Power for DIV255
Wiring AC-DC Power for DIV256
Wiring AC-DC Power for Zone258
Wiring External DC Power60
MIWI350 as Power Box61
Wiring Dual or Quad Battery for MIWIPCB61
Wiring Solar or External DC (13.5 to 15V DC) Power for MIWIPCB63
Wiring AC DC Power for MIWIPCB64
Wiring External DC Power for MIWIPCB65
MIWI350 as Power or Communication Box66
Barrier Connections66
With Cloudlink MODEM66
With Cloudlink 4G M1 MODEM67
With RV50/RV50X/RV55 MODEM69
Terminal Block Connections72
With Cloudlink MODEM72
With Cloudlink 4G M1 MODEM73
With RV50/RV50X/RV55 MODEM75
Configuration Software77
350S Audit Trail Log Support for Cloudlink MODEM78
As Shipped Configuration Reload Procedure81
Orderable Kits83

Honeywell MIWI350 - 5.2.2 Power Distribution Board jumper settings for Alkaline Battery or DC input

Table of Contents

Other manuals for Honeywell MIWI350

Related product manuals