Honeywell MX9 - Factory Default Settings

Factory Default Settings
Main Tab
Device 1 Disabled
Device 2 Internal
Device 3 Disabled
Scan Mode - Continuous Disabled
Same Symbol Timeout Dimmed (1.0s)
Send Key Message (WEDGE) Enabled
COM1 Tab (External serial port)
Baud Rate 9600
Stop Bits 1
Parity None
Data Bits 8
Power on Pin 9 Disabled
Notification Tab
Enable Internal Scanner Sound Enabled
Good Scan Vibration Off
Bad Scan Vibration Off
Processing Tab
Enable buffered key output Enabled
Same buffer limit 32
Delay between buffers 75 ms
Data Options
Enable Code ID None
Symbology Settings All
Control Character Translate All Disabled
Custom IDs Name blank
HHP Properties
Options Disabled:
Centering
DecodeMode
LinearRange
AimTimer
LeaveLightsOn
HHP - Hand Held Products
4-83