Using LXEConnect
1. If an ActiveSync connection has not been established, connect the MX9 to the PC.
2. Double-click the LXEConnect icon that was created on the desktop.
3. LXEConnect launches.
4. Click the OK button to dismiss the About CERDisp dialog box on the MX9 desktop by clicking the OK button in the
LXEConnect window on the PC desktop. The dialog box automatically times out and disappears after approximately 30
seconds.
5. The MX9 can now be configured from the LXEConnect window.Input from the PC’s mouse and keyboard are
recognized as if they were attached to the MX9.
6. When the remote session is completed, terminate the LXEConnect program by selecting File > Exit or clicking on the X
in the upper right hand corner to close the application, then disconnect the ActiveSync cable.
Note: After using LXEConnect, the MX9 cannot go into Suspend mode until after a warmboot. If using Power Management
on a MX9, always warmboot the MX9 when finished using LXEConnect.
5-10
To Next Page
Loading...
