184 N4680 2D Decoded Scan Engine User Guide
This response indicates that Codabar Coding Enable (CBRENA) has a range of val-
ues from 0 to 1 (off and on).
Example: What is the default value for Codabar Coding Enable?
This response indicates that the default setting for Codabar Coding Enable
(CBRENA) is 1, or on.
Example: What is the device’s current setting for Codabar Coding Enable?
This response indicates that the device’s Codabar Coding Enable (CBRENA) is set
to 1, or on.
Example: What are the device’s settings for all Codabar selections?
This response indicates that the device’s Codabar Coding Enable (CBRENA) is set
to 1, or on
• The Start/Stop Character (SSX) is set to 0, or Don’t Transmit
• The Check Character (CK2) is set to 0, or Not Required
• Concatenation (CCT) is set to 1, or Enabled
• The Minimum Message Length (MIN) is set to 2 characters
• The Maximum Message Length (MAX) is set to 60 characters
• Default setting (DFT) has no value.
Enter: cbrena*.
Response: CBRENA0-1[ACK]
Enter: cbrena^.
Response: CBRENA1[ACK]
Enter: cbrena?.
Response: CBRENA1[ACK]
Enter: cbrena?.
Response: CBRENA1[ACK],
SSX0[ACK],
CK20[ACK],
CCT1[ACK],
MIN2[ACK],
MAX60[ACK],
DFT[ACK].
To Next Page
Loading...
