Honeywell N4680 - LED Illumination - Presentation Mode

36 N4680 2D Decoded Scan Engine User Guide
Enhanced mode will give you the highest possible scan speed but slightly less
range than Normal mode. Enhanced mode is best used when you require a very
fast scan speed and don’t require a long working range.
When using Preferred Symbology (page 3-51), a lower priority symbol must be
centered on the aiming pattern to be read in Streaming Presentation Mode.
LED Illumination - Presentation Mode
If you wish to set the illumination LED brightness, scan one of the bar codes below.
This sets the LED illumination for the scanner when it is in Presentation Mode. (If
the scanner is triggered manually, the LED illumination will switch to the setting
for a manual trigger. See "LED Illumination - Manual Trigger" on page 32.) Default
= High.
Note: The LEDs are like a flash on a camera. The lower the ambient light in the room, the
brighter the LEDs need to be so the scanner can “see” the bar codes.
Note: Lower LED illumination settings are more visible to the user on rolling shutter
engines than global shutter engines.
Note: LED Illumination - Presentation Mode does not apply to Streaming Presentation™
Mode or Mobile Phone Read Mode.
Streaming Presentation
Mode - Normal
Streaming Presentation
Mode - Enhanced
Off
Low
* High