Honeywell oneWireless XYR 6000 - IS Battery Pack, 50047517-501; IS Battery Pack Replacement Procedure; Figure 5-2: IS Battery Pack

5. Start up
Battery Power Option
50 OneWireless XYR 6000 Transmitters Quick Start Guide Revision 12
February 2013
IS Battery Pack, 50047517-501
IS Battery Pack replacement procedure
Step Action
1
Follow steps 1-4, as above
2
WARNING
DO NOT ASSEMBLE/DISASSEMBLE WHEN AN EXPLOSIVE ATMOSPHERE IS PRESENT
Figure 5-2: IS Battery Pack
3
Remove top of battery pack by using a #1 Philips or 1/8” slotted screwdriver for the screws
identified as #1 in Figure 5-2.
4
Remove the spent batteries and dispose of them promptly according to local regulations of the
battery manufacturer’s recommendations.
5
Install the batteries following the polarity as noted on the lid
6
Re-install top of the battery pack and tighten screws
7
Insert the Battery pack into the transmitter. Re-attach the screws as indicated in Figure 5-1,
item 3, to 0.4 to 0.6 N-M (3.5 – 5.3 Lb-in).
Reconnect the Battery Pack connector
Honeywell recommends lubricating the end cap threads with a silicone grease such as Dow
Corning #55 or equivalent before replacing the end cap
8
Screw the cap back on and tighten the M3 locking screw