800-22757 - A - 02/2017
2
Getting Started with the ConfigTool 2
This chapter contains the following sections:
• Installing the ConfigTool IP Utility, page 13
• Discovering Your Device on the Network, page 14
• Assigning a New IP Address to Your Device, page 14
• Upgrading the Device’s Firmware, page 15
• Opening a Web Client, page 18
Installing the ConfigTool IP Utility
Before you can start using your camera, you must install the ConfigTool IP utility on your PC.
1. Insert the software CD that came with your camera into your PC’s disk drive.
2. Open the
Honeywell Config Tool
folder, and then double-click
Honeywell ConfigTool.exe
.
3. Click
Next
on the ConfigTool welcome screen.
4. Read the User License Agreement. If you agree, select
I agree
.
5. If you want, you can change the installation directory (by default, ConfigTool will be installed
in C:\Program Files). To proceed with the installation, click
Install
.
6. If the installation is successful, the message
Installation is complete!
appears.
Click
Enjoy Now
to open ConfigTool.
To Next Page
Loading...
