EasyManua.ls Logo

Honeywell PRIMUS 1000 - Flight Level Change Descend and Climb Parameters; Altitude Preselect (Asel) Mode

Honeywell PRIMUS 1000
334 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PRIMUSr 1000 Integrated Avionics System
A28--1146--112--00
Modes of Operation
8-32
Direction Altitude
Preprogrammed
Values
Descend All altitudes --2000 fpm
0--10,000 feet 240 knots
10,000 feet to
12,000 feet
240 knots to 270
knots linearly
Climb
12,000 feet to
17,377 feet
270 knots
17,377 feet to
37,000 feet
0.56 Mach
Flight Level Change Descend and Climb Parameters
Table 8--8
When the FLC button is pushed, the SPD or V/S modes are not
available. In CLB, the SPD hold mode control laws are used. In DES,
the VS holdcontrol lawsare used.When theTCSbuttonispushedand
held,thepitchandrollautopilotservosaredisengaged andthepilotcan
maneuver the aircraft. When the TCS button is released, the FGS
returns the aircraft to the preset FLC target.
In FLC, all armed pitch flight director modes are allowed, but if any
armed pitch mode is captured, the FLC mode is overridden.
NOTE: During an FLC descent, the normally available airspeed/Mach
reference bug and digital display are removed.
TheFLCmodeiscancelledbyanyoneofthe followingactionsorevent:
D Pushing the FLC button on the GC
D Selecting any other vertical mode on, or captured
D Switching to SG reversionary mode
D Selecting go--around
D Coupling to cross--side FD
D Coupled side MADC or AHRU goes invalid.
ALTITUDE PRESELECT (ASEL) MODE
The ASEL mode is used in conjunction with another vertical mode to
automatically capture, level off, and hold the altitude that was set with
the ASEL knob on the GC. The altitude preselect mode captures and

Table of Contents

Related product manuals