12 PW-7000 (PW7K1IC) Installation and Configuration Guide, Document 800-25673V1
Confidentiality
All software, drawings, diagrams, specifications, catalogs, literature, manuals and
other materials furnished by Honeywell Integrated Security relating to the design,
use and service of the Products shall remain confidential and shall constitute the
proprietary rights of Honeywell Integrated Security and Customer agrees to treat
such information as confidential. Customer shall acquire no rights in the design of
the Products or the related materials except to use such information solely for the
purpose of and only during the time it sells the Products.
Customer shall not copy the design of any of the Products or use or cause to be
used any Product design or related materials for its own benefit or for the benefit of
any other party. The covenants contained in this section shall remain effective
throughout the term of this Agreement and thereafter unless specifically waived by
Honeywell Integrated Security in writing.
Compliance
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB- 003 du Can-
ada.
To obtain applicable EU compliance Declaration of Conformities for this product,
please refer to our website, https://www.security.honeywell.com/All-Categories/
access-control-systems/control-panels-hardware.
For any additional information regarding the compliance of this product to any
EU-specific requirements, please contact:
Honeywell Security & Communications
Honeywell Security - Quality Assurance Dept., Newhouse Industrial Estate Mother-
well
Lanarkshire ML1 5SB Scotland
United Kingdom
Tel: +44(0) 1698 738200
Email: UK64Sales@Honeywell.com
Recommended testing and maintenance
Perform the following on a semi-annual basis. Disconnect power from the enclo-
sure, open the enclosure door and inspect the system including the DC battery.
Replace the DC battery if it shows any sign of corrosion or leakage or if the battery
is 2 years old or older. Oil the lock cylinder. Close the panel and re-apply power.
To Next Page
Loading...
