Honeywell RLV4300 - Display

5
Automatic mode
To place the thermostat in Automatic mode, press the Mode button
until Auto appears on the screen. The current period number also
appears.
In this mode, the thermostat follows the programmed schedule.
You can program up to 4 periods in a day. You can set 2 different
programs: one for the weekdays (Monday to Friday) and another one
for the weekend (Saturday and Sunday).
By default, the thermostat is programmed with the following schedule:
Monday to Friday Saturday & Sunday
Period Start Time Temperature Start Time Temperature
1 Wake 6:00 21.0°C (70°F) 6:00 21.0°C (70°F)
2 Leave 8:00 16.5°C (62°F) --:-- - -
3 Return 18:00 21.0°C (70°F) --:-- - -
4 Sleep 22:00 16.5°C (62°F) 22:00 16.5°C (62°F)
Temporary Override
You can temporarily override the current temperature using the Up or Down
button. The new setpoint will be used until the end of the current period. During
the override, Auto flashes on the screen.
Clock and day setting
The clock must be set when Time appears on the screen.
1. Pull the cover down.
2. Press the Day button to set the day.
3. Use the Hour and Min buttons to set the clock.
4. Press the Ret button to exit.
Temperature display and setting
The thermostat normally displays the room (measured) temperature.
• To display the set temperature (setpoint), press the Up or Down button once.
The setpoint temperature will remain on the screen for 5 seconds.
• To change the setpoint temperature, press the Up or Down button repeatedly
until the desired temperature is displayed.
• The screen is backlit for 12 seconds when any button is pressed.