Owner’s Guide
6
1) Push the excess wires back inside
the electrical box.
2) Secure the thermostat to the
electrical box using the provided
screws.
3) Insert the screws through either the
right or left pair of mounting holes
on the thermostat.
NOTE: If there is a protective film or
sticker on the thermostat’s screen, peel it
off.
4) Apply power to the heating system. Verify the installation by
checking that the heater can be turned on by raising the setpoint
using the Up button and off by lowering the setpoint using the
Down button.
WARNING: Keep the thermostat's air vents clean and free from
obstructions.
Thermostat mounting
69-2613ES-01.book Page 6 Thursday, November 10, 2011 11:38 AM
To Next Page
Loading...
