Installation
2106M0525 Iss 2 Nov 05 16
3 Close the lid of the enclosure and secure it.
Cautions Ensure there is no moisture inside the enclosure before closing
the lid.
Ensure the seal, between the body and the cover, is correctly
located and is secure.
Ensure the cover is securely clamped to the body of the enclosure.
Use only the captive fixing screws supplied, replacement with
alternative screws will invalidate certification.
Fully tighten the four M4 captive securing hex screws.
4 Carry out one of the following two procedures.
+ Supply (red)
Signal (blue)
Screen
(braided wire)
Toxic/Oxygen
Detector
Center Tap
(white)
Non-
Sensitive
Element
(blue)
Sensitive
Element
(brown)
Earth
Terminal
Flammable
Detector
To Next Page
Loading...
