Honeywell Sensepoint - Page 18

Installation
2106M0525 Iss 2 Nov 05 18
d. Remove the supplied RFI screen and inner filter from the packing bag.
e. Fit the two components to the sensor.
Fit them in the order shown in the diagram. Insert both of them evenly. Push the inner filter
into the neck of the sensor body until its locating tags click into place.
f. Refit the sensor cap.
Screw the cap in a clockwise direction. If required fit an accessory. Refer to the instructions
supplied with the item except for fitting outer filters, see page 19.
 Power the unit and check for correct operation of the detector.
Check the gas reading at the controller. Refer to the controller’s user documentation.
e
Protective
Disc
x
x
x
x
x
x
x
x
x
x
x
x
x
X
x
x
x
x
x
x
x
x x
x
x
x
x
X
b
Sensor Cap
Cell
Protective Plug
c
adhesive face
a
f
Counter-clockwise Clockwise
d
Packing
Bag
RFI
Screen
Inner
Filter
Sensor Body
Cell
Oxygen ONLY
Oxygen ONLY