Installation
2106M0525 Iss 2 Nov 05 19
Accessories
The following accessories are available for use with the detector:
• weather housing
• flow housing
• collecting cone
• filters
Also see page 28.
To fit all the accessories refer to the instructions supplied with the item, except for fitting outer filters,
see the following procedure.
Fitting an Outer Filter
This procedure applies to all types of Sensepoint gas detector. Refer to the following diagram.
1 Remove the sensor cap (or accessory).
Unscrew the cap/accessory in a counter-clockwise direction.
2 Fit the outer filter.
The filter fits inside the Sensor Cap.
3 Refit the sensor cap (or accessory).
Screw the cap/accessory firmly in a clockwise direction.
Sensor Body
1
3
Sensor Cap
Counter-
clockwise
Clockwise
Outer Filter
2
To Next Page
Loading...
