10 6700 Manual — P/N LS10148-001SK-E:F 8/29/2022
Introduction About this Manual
1.2 About this Manual
This manual is intended to be a complete reference for all installation and operation tasks for the 6700.
1.2.1 Terms Used in this Manual
The following terminology is used with the 6700 system:
1.3 Compatible Products
The chart below lists the products available for use with the 6700.
Term Description
SLC Signaling Line Circuit
Module The term module is used for all hardware devices except for SLC addressable devices and notification
appliances. This includes the 6700 panel itself.
Input Point An addressable sensing device, such as a smoke or heat detector or a contact monitor device.
Input Zone A protected area made up of input points.
Output Point (or Output Circuit) A notification point or circuit for notification appliances. Relay circuits and auxiliary power circuits are also
considered output points.
Group (or “Output Group”) A group of output points. Operating characteristics are common to all output points in the group.
Output (or “Cadence”) Pattern The pattern that the output will use, for example, Constant, March Code, ANSI 3.41. Applies to zones
and special system events. See Appendix D for additional information.
Mapping Mapping is the process of specifying which outputs are activated when certain events occur in the
system. Figure 7.2 describes mapping in detail.
Common Communication Link Up to 17 panels can be linked. Consist of any combination of 17 panels of these model numbers: 6700,
6808, 6820 / 6820EVS. For reporting purposes only. Not a peer-to-peer networked system.
SWIFT Smart Wireless Integrated Fire Technology
Table 1.1 Manual Terminology
Type of Device Model Description
SK Addressable SLC Devices For a list of compatible devices, refer to the SLC Wiring Manual, P/N: LS10179-000SK-E.
SD Addressable SLC Devices
SWIFT Wireless SLC Devices For a list of compatible devices, refer to the SWIFT Manual, P/N: LS10036-000SK-E.
Other Modules 5824 Serial/Parallel
Printer Interface Module
Allows a printer to be attached for the on-site event logging. Maximum of four 5824s per
control panel.
5895XL Power Supply Provides additional power, six Flexput circuits, and two Form C relays. Max 8 per system. See
5895XL Installation Manual (PN 151142) for more information.
5496 NAC Expander Provides 4 additional Notification Appliance Circuits/Auxiliary power. (Up to 8 per 6700
System).
6855 and 5860 LCD
Annunciator
4 x20 Remote LCD annunciator. Can be used in any combination, up to a total of 8 devices on
one panel.
6860LCD Annunciator 4 x 40 Remote LCD annunciator can be used in any combination, up to a total of 8 devices on
one panel.
5865-3 and
5865-4 LED
Annunciator
LED annunciator can display up to 30 LEDs (15 red and 15 yellow). 5865-4 has key switches
for silence and reset, and a system trouble LED. 5865-3, 5865-4, and 5880 can be used in
any combination, up to a total of eight devices on one panel.
RA-100TR Trim Ring Trim ring kit for surface mounting the 6860/6855 annunciators.
5860TG and 5860TR
Trim Rings
Trim ring kits for surface mounting the 5860/5860R annunciator. 5860TG is gray; 5860TR is
red.
5880 LED Driver
Module
Driver for up to 40 LEDs. Interfaces with customized annunciator boards. In addition the 5880
has eight generic switch input points.
5883 General Purpose
Relay Module
Provides 10 Form C relays. Designed to be driven by the 5880. Up to four, 5883s can be used
with each 5880 module.
SK-NIC Network Interface Card
SK-FML Fiber-Optic Multi Mode
SK-FSL Fiber-Optic Single Mode
Table 1.2 6700 Compatible Products
To Next Page
Loading...
