Honeywell SILENT KNIGHT 6700 - 5: Transmitter Activated by Dry Contacts

6700 Manual — P/N LS10148-001SK-E:F 8/29/2022 51
Remote Station Applications Control Panel Installation
.
2. Program the NAC circuit as a non silence NAC circuit (see Section 8.5.2).
4.18.5 Transmitter Activated by Dry Contacts
This section describes the connection of a UL 864 listed remote station transmitter to the 6700 FACP dry contacts. The FACP contacts must
be supervised by the remote station transmitter module using end-of-line resistors (ELRs) with a value determined by the transmitter manu-
facturer. Power is also provided by the remote station transmitter manufacturer. Refer to the remote station transmitter manufacturer’s man-
ual for details.
0 24 115 230
NO C NC NO C NC
NO NC C
TROUBLE
RELAY 2
C NO NC
RELAY 1
C NO NC
SLC IN
+
_
SLC OUT SLC PROG
+
_
+
_
SBUS
A
B
+
_
NAC 1
NAC 2
to remote
receiving
station
4.7k UL-
listed EOL
1kΩ
resistor
Intended for connection to a polarity
reversal circuit of a remote station
receiving unit having compatible rating.
MR-201
UL
Listed
EOLs
Figure 4.47 Polarity Reversal Connection Using the MR-201/T Relay
NOTE: If you need to transmit supervisory or trouble conditions, additional relay modules must be added. Use relay 1 to transmit supervisory
conditions. Use the trouble relay to transmit trouble conditions..
NO NC C
TROUBLE
RELAY 2
C NO NC
RELAY 1
C NO NC
SLC IN
+
_
SLC OUT SLC PROG
+
_
+
_
SBUS
A
B
+
_
NAC 1
NAC 2
The Trouble relay is a fail-safe
relay. With power applied to the
FACP and no troubles in the
panel, the contacts should be in
the condition indicated.
supervisory
alarm
trouble
Do not loop wires under terminals.
Break wire runs to provide proper
supervision of connections.
typical input
zone triggers
transmitter
activated by
dry contacts
Figure 4.48 Transmitter Activated by Dry Contacts