Page 4 ST 700 SmartLine Pressure Transmitters User’s Manual Revision 13
2.1.1 Physical Characteristics
As shown in Figure 1, the ST 700 standard is packaged in two major assemblies: the electronics
housing and the meter body. The elements in the electronic housing respond to setup commands and
execute the software and protocol for the different pressure measurement types. Figure 2 shows the
assemblies in the electronics housing with available options.
The meter body provides connection to a process system. Several physical interface configurations
are available, as determined by the mounting and mechanical connections, all of which are described
in the Installation section of this manual.
Figure 1 – ST 700 Standard Transmitter Major Assemblies
Figure 2 – ST 700 Standard Transmitter Electronics Housing
Components
To Next Page
Loading...
