Page 198 ST 700 SmartLine Pressure Transmitters User’s Manual Revision 13
13.2.3 Data Entry
Data entry is performed from left to right. Select a character / digit by pressing buttons, and then
press to advance to the next character position to the right. Select the cross-hatch character ▒ to
terminate the entry or if the final character is already a space character, just press << again.
All numeric entries are clamped at the low or high limit if needed. You can determine the low and
high limit for a parameter by selecting either the H or L character while the cursor is positioned over
the left-most digit and press button. The display will show the selected limit.
For numeric entry sign is required to be entered only for negative numbers. For positive number,
select space and move ahead.
Table 37 – ST 700 Basic Transmitter - Two-Button Data Entry
Display the high limit for this parameter.
This symbol only appears in the left-most position of the data entry field.
Display the low limit for this parameter.
This symbol only appears in the left-most position of the data entry field.
These characters are used to enter numeric values. The minus sign
only appears in the left-most digit.
To Next Page
Loading...
