Honeywell SMV800 - Page 153

Revision 1.0 SMV800 Modbus User's Guide Page 141
Reserve
189
Reserve Address
NA
NA
Totalizer
Status
190
Totalizer Process Variable
Status
0x30 TOTALIZER OFF
0x00 TOTALIZER BAD
0x40 TOTALIZER
POOR ACCURACY
0x80 TOTALIZER
FLOW SIMULATION ON
0xC0 TOTALIZER
GOOD
0xB0 TOTALIZER STOP
Sampling Rate
191
The Totalizer value will be
updated at the configured
rate. The rate may be
configured in increments of
125 ms.
RW
uint16
Totalizer
Status Latency
192
The userconfigurable
Totalizer Status Latency
indicates the length of time
this status will be active
before it is reset.
RW
uint16
Totalizer
Custom Unit
Tag
193
User defined Tag for
Totalizer custom unit
selection. This field can hold
numbers, symbols, upper-
case letters (8 characters)
RW
ASCII
Reserve
197
Reserve Address
NA
NA
Totalizer
Exceed Count
198
This value indicates the
number of times the
Totalizer Value has
reached the userconfigured
Maximum
Totalizer Value
RO
uint16
Start/Stop
Totalizer
[M]Reset
Totalizer
199
Reset Totalizer Mode and
Values
RW
uint16
Bit 0 : Start/Stop . Set to 1
for Start
Bit 1 : Reset Positive
Totalizer. Set to 1 for
Reset
Bit 2 : Reset Negative
Totalizer. Set to 1 for
Reset
Bit 3 : Reset Totalizer
Exceed Counter. Set to 1
for Reset
DP Current
URV
Correction
Time and Date
204
Current time record for DP
URV Correction
RO
uint32
N/A
DP Current
LRV
Correction
Time and Date
206
Current time record for DP
LRV Correction
RO
uint32
N/A
DP Current
Zero
Correction
Time and Date
208
Current time record for DP
Zero Correction
RO
uint32
N/A