Page 170 ST 700 Series HART/DE Option User’s Manual Revision 4.0
20.6 Basic Setup Page
20.6.1 Pressure Transfer Fn:
Allows for selecting the Transfer function; Linear or Square Root.
20.6.2 Low Flow Cutoff Mode:
Allows for selecting the User Config Mode and entering the Low Flow Cutoff breakpoint from 0-25%
to get the needed signal conditioning. Refer to Table 36 for more details
20.6.3 Device Information
Allows access to both read-only parameters and read/write parameters.
Provides access to Message, Clear Message and Maint Mode.
Refer to Table 36 for more details
20.6.4 Model Number:
Shows the Model number.
20.6.5 Device Assembly:
Shows the Blow out Image of ST 700
20.6.6 System Setup:
Shows the Image how to connect the Transmitter
To Next Page
Loading...
