Honeywell Stratos 2700 - Interleaved 2 of 5

9 - 8
the Programming Chart on the inside the back cover of this manual. The data characters should then appear properly.
Interleaved 2 of 5
Interleaved 2 of 5 On/Off
NULL Characters
Interleaved 2 of 5 requires an even number of characters. When an odd number of characters is present, it is due to NULL
characters embedded in the bar code. Scan the On bar code below to decode this type of Interleaved 2 of 5 bar code.
Default = Off.
Check Digit
No Check Digit indicates that the scanner reads and transmits bar code data with or without a check digit.
When Check Digit is set to Validate, but Don’t Transmit, the unit only reads Interleaved 2 of 5 bar codes printed with a
check digit, but will not transmit the check digit with the scanned data.
Code 39 Code Page
Default All Interleaved 2 of 5 Settings
On
* Off
* Off
On