Honeywell Stratos 2700 - Code 11; Check Digits Required

9 - 17
Code 11
Code 11 On/Off
Check Digits Required
These options set whether 1 or 2 check digits are required with Code 11 bar codes. The check digit data is only transmitted
if you program that feature (see Check Digit Validation on page 9-17). Default = Two Check Digits Required.
Check Digit Validation
When Check Character is set to Validate and Transmit, the scanner will only read Code 11 bar codes printed with the
specified type check character(s), and will transmit the character(s) at the end of the scanned data.
Default All Code 11 Settings
On
* Off
One Check Digit Required
* Two Check Digits Required
Validate and Transmit One
Check Digit
Validate and Transmit Two
Check Digits