18 https://extranet.honeywell.com
7 Connect the cables to the 3.5mm Pitch Plugs using the 0-1 screwdriver.
Make sure that there are no short circuits between the wires. There is
only one way to insert the connectors (see
Figure 6).
8 Plug the RJ45 connector into the Ethernet port and other cables if
present.
9 Arrange the cables so that the connectors are on the same side of their
sockets without crossing the cables.
10 Check the right position of the gasket.
Figure 6 Cable illustration for tamper switch installation
To Next Page
Loading...
