1.5 Connect wires.
1.5a Strip back insulation from conductors
by 8mm.
1.5b Connect wires to terminals as shown by
pushing bare end of conductor into holes
in wiring terminals. The wires will be
gripped by the internal mechanism.
1.5c Check each wire is securely connected
by giving it a gentle pull.
8mm
N L C B A
Note: to disconnect any wire, press on the tab next
to it then pull the wire out from the terminal hole.
See Step 2: Wiring schematics for details.
Earth
Step 1: Wallplate installation and wiring continued
P8
To Next Page
Loading...
