Honeywell TL9160AR - Verifying Signal Strength; Checking EIM-Thermostat Connection; Replacing Wireless Devices; Thermostat Replacement Procedure

System Installation Guide
69-2474EFS—01 22
Verifying the signal strength between the EIM and the thermostat
Replacing wireless devices
IfyouhavemorethanoneEIMlinkedtothethermostat,thedisplayedvalueisbetween
thethermostatandtherst-linkedEIM.Thesignalstrengthrangesfrom0(nosignal)to10
(strongest).
# Display Button Step
1)
Fromthehomescreen,press
andholdtherightcenter
buttonfor5secs.
2)
Press toselectLinkand
pressOK.
3)
Press toselectStrength
andpressOK.
4)
Thesignalstrengthis
displayed.PressExittwice
toreturntoinstaller’ssetup
menuorthreetimestoreturn
tohomescreen.
Thermostat
Toreplacethethermostat,installbatteriesinthenewthermostat(seepage7)andlinkitto
thewirelessnetwork(seepage8).Tocustomizethethermostat,seepages11-18.
IfmorethanoneEIMwerelinkedtotheoldthermostat,youcanlinkthenew
thermostatfromanyoneoftheseEIMs.