(C) OPERATING THE HEADSET GETTING STARTED
CONNECT TO PERSONAL NOISE EXPOSURE APP
Enable Bluetooth on your mobile device and ensure the mobile device is within 10m of the
headset. The headset is connected through the App. Next time the headset is turned on, it will try
automatically connect.
CONNECT TO PERSONAL NOISE EXPOSURE APP
First time pairing Open the app and follow on-screen instructions
Finding a headset Initiate from app *C4 flashing blue
Confirm a connected headset
Open the app and follow on-screen
instructions. Press *C1 Once
*C4 solid blue 2s
Clear Connected Headsets Hold *C1 10s while powering on * C4 flashing blue, red
Cancel Connection Press *C2 in connection process
PERSONAL NOISE EXPOSURE MONITORING
Dose safe (0-85%) *C3 blinks green
Dose warning (85%-100%) *C3 blinks orange + Warning tone
Dose Alarm (Above 100%) *C3 blinks red + Warning tone
Reset Dose Hold *C2 for 5s
On success, *C3 double flashes green + audio tone
Silence Dose Alarm Press *C2 Audio tone off. *C3 flashes red and stops.
Dose status voice message Press *C2
Dose level low (0-40%)
Dose level medium (41-70%)
Dose level high (71-100%)
Dose level too high (100+%)
FIT TEST (MAY BE ALSO ACTIVATED THROUGH THE APP)
Perform Fit test Double press *C2 Repeated audio tone + Voice Feedback
Fit test result: Good fit Positive audio tone + Voice Feedback
Fit test result: Poor fit Negative audio tone + Voice Feedback
Fit test result: Not available Voice message; Fit test not possible
GETTING STARTED
Power On
Power Off
Hold *C1 for 3s
Audio Tone and *C4 solid green 5s
Audio Tone and *C4 flashes red
Adjust hear-through volume
Rotate dial *C5 Ambient volume +/-
Auto shut off No activity in 4 hours Audio Tone and *C4 flashes red
HEADSET CONTROLS
C1
Power Button
C5
Hear-Through Dial
C9
Pairing Indicator
C2
Dose Button
C6
Multi-Function Button
C10
USB C & Charging Indicator
C3
Dose Indicator
C7
Volume Button Up
C11
Microphone for voice calls
C4
Power Indicator
C8
Volume Button Down
To Next Page
Loading...
General