VisionPRO TM 8000 Touchscreen Programmable Thermostat
THERMOSTAT
COOL
PROPORTIONAL COOL
CONTROL POINT
P+I CONTROL m_._a
POINT
P+l CONTROL POINT
X__O_O2,Oo%HEAT
L- THERMOSTAT
HEAT SETPOINT
m
HEATING =k COOLING
I-
I I
100 50 0 50 100
PERCENT LOAD M4414
Fig. 31. Proportional temperature control versus P+ I
temperature control.
MinimumOff-Timer
The Thermostat has built-in compressor protection (minimum-
off timer) that prevents the compressor from restarting too
early after a shutdown.
The minimum-off timer is activated after the compressor turns
off.
If there is a call during the minimum-off timer, the thermostat
shows "Wait" in the display.
WED
_ "_s'd°""lI I
S: I I _
Setf° mllWaitI-it
Following
Schedule
.0LDI[CL0CK
M22244
Inside Humidity Level
Select models can sense the humidity level in the home. The
humidity level in the home is shown in the lower right corner of
the Home Screen.
TUE
i Oj, s,d!ZO Se,.o,--.
ICU uJ °'z
Following
Schedule
,_ I1-1.t I1-f --I --I %
ILr 7 aZaP_ ZnpZ
Humidity
M19966
If thermostat is set to Auto Changeover System mode, press
the More key until the humidity level is shown on the screen.
M22452
When the minimum-off timer expires, "Cool On" or "Heat On ''a
appears solidly in the display and the compressor and fan turn
on.
aHeat Pumps only.
68-0280 32
To Next Page
Loading...
